If you need the arrangement of your space to be mobile or you just do not like monotony, choose planters with wheels. Wheels in which our planters can be equipped allow a quick change of arrangement, which is often needed (e.g. in restaurants, hotels or cafes). We make sure that the wheels do not negatively affect the appearance of our products. That is why they are hidden under the raised bottom and practically invisible. Your planter will give the illusion of floating about a centimeter above the ground. Remember, however, that you need an even and hard surface to move planters.
On request, the walls of our planters can be insulated. Isolation helps to protect the rootballs of the plant from freezing in the winter and excessive heating in the summer. To make our insulation, we use an extruded polystyrene , a material commonly used for insulating building foundations. It has a significantly better insulation factor than styrofoam. Unlike styrofoam, it does not absorb moisture, does not degrade over time, and its hardness makes it resistant to soil pressure and root work. In the case of planters, we use a rubber foam that has similar parameters to extruded polystyrene .
Sometimes there is a need to set planters on uneven ground, for example directly on a sloped roof. In order to make the planters stand horizontally, we have designed simple feet that have the ability to change their height and angle of inclination. Therefore, they not only raise the planters, but also bring them to level. At the same time, they give the opportunity to drain water from the planter, making it easier to clean the terrace. In addition, from the inside of the planter, Allen screws make it easy to change the height of the stands after setting the planter in place. If the equipment is set on the terrace deck – rainwater is allowed to flow between the boards without creating puddles. The feet have a large contact surface with the ground, so that they can also be set on a softer floor, e.g. directly on styrodur in the case of green roofs. Pots equipped with stands allow you to maintain a beautiful and functional terrace for many years.
We use only professional LED strips produced in Poland to highlight our products. By using brand-name OSRAM LEDs for years, our LED bars have consistent color and brightness and do not burn out over time. We guarantee all our products meet the same high level of quality.
All LED tapes and bars are designed for outdoor use and have a minimum IP65 water resistance class. It is possible to power 12V or 24V DC using typical transformers for LED strips.
LED lighting fixtures allow you to display plants at dusk and create mood lighting around planters. Strips are completely resistant to atmospheric conditions and moisture. They are powered at a safe voltage of 12V / 24V, and slightly warm in color. For planters with straight edges, the LED bars are fastened to the inner side of the top of the planter. Special connectors for adjusting the angle of light and easy assembly and disassembly of the light bar. Strips are terminated with a 2 m long cable and are supplied without a transformer.
If you want your plant to have a constant supply of water, we can equip planters with an elevated drain. As a result, excess rainwater or water from the irrigation system will be collected on the bottom creating a water reservoir there. Remember that the drainage layer should reach over the drain. The drain should be covered with geotextile to protect it from clogging.
If you intend to use climbing plants, the integrated trellis will enable appropriate conditions for their upward growth. As a result you can create green walls to divide space and separate intimate corners. A trellis will also provide adequate support for fragile plants exposed to wind breakage. In round pots, a trellis is mounted in the middle, and in rectangular pots in the middle or at the edge of the planter. Each trellis has the ability to adjust the angle of inclination to allow for vertical installation despite possible unevenness of the ground.